Garbage Disposal Repair in Billings, MT
A humming disposal is almost never a dead disposal — it's a jammed impeller or a tripped overload, and either one is a quick fix. We repair and replace disposals across Billings, usually in a single short visit.
Call (406) 625-4316
Common Disposal Problems We Fix
- Humming but not spinning — a jammed impeller nine times out of ten. We clear the jam, check the bearings, and reset the overload.
- Completely dead — tripped reset button, a failed wall switch, or a dead motor. Two of the three cost almost nothing.
- Leaking under the sink — sink flange, dishwasher inlet hose, discharge connection, or a cracked body. We find the actual source; only the last one means a new unit.
- Draining slowly or backing up — clogged discharge lines and traps. If the blockage is deeper in the drain plumbing, we'll tell you it's a plumber's job before you pay us to prove it.
- Grinding metal noise — a dropped utensil or a failed bearing; one is free to fix, and we'll tell you which you have.
Replacement Installs, Same Visit
When a motor is genuinely burned out or the housing is cracked, repair stops making sense — disposals are the one appliance where replacement is often the honest answer. We stock common sizes and can usually swap a like-for-like unit the same visit: InSinkErator, Badger, Moen, and Waste King, matched to your sink flange and dishwasher connection. Existing wiring and plumbing stay put; new circuits or drain rework go to an electrician or plumber first, and we'll say so upfront.
What Not to Put Down a Disposal
The jams we clear in Billings kitchens have a familiar cast: fibrous vegetable peels, coffee grounds in bulk, grease that sets up in the trap come winter, and fruit pits. A disposal grinds scraps; it isn't a second trash can. Cold water running before, during, and after grinding prevents most of the calls on this page — we'd still rather you call us than fight a jam with a broom handle.
How It Works
Call (406) 625-4316 or send the request form. Jams and resets are quick, flat, quoted work; replacements get a written quote — unit, labor, total — before anything comes off the sink.
Sink Out of Commission?
Call (406) 625-4316 or request a window online — Monday through Saturday, 8 AM to 6 PM Mountain Time.